DIYgh Tech Store
Showing 46–60 of 78 results
IR Infrared Obstacle Avoidance Sensor Module | FC-51 for Arduino
-
Detection Range: 2cm - 30cm (Adjustable).
-
Output: Digital Signal (LOW when obstacle detected).
-
Compatibility: Works directly with Arduino, ESP32, and Raspberry Pi.
-
Best For: Robot Cars, Smart Trash Cans, and Proximity Alarms.
IRF520 MOSFET Driver Module (0-24V) | PWM Motor & LED Controller
-
Max Load: 24V DC / < 5A.
-
Control Voltage: 3.3V or 5V (PWM Compatible).
-
Output: Pulse Width Modulation (Speed/Dimming control).
-
Best For: LED Strips, Small DC Fans, and Solenoids.
IRLZ44N Logic Level MOSFET (N-Channel) | Arduino Compatible Transistor
Control high-power loads directly from your Arduino or ESP32. The IRLZ44N is a true logic-level MOSFET, meaning it fully turns on with 3.3 V or 5 V gate signals. Unlike the common IRFZ44N, it does not require a gate driver, making it ideal for simple and efficient microcontroller projects.
-
Type: Logic-Level N-Channel MOSFET
-
Maximum Voltage / Current: 55 V / 47 A
-
Gate (Control) Voltage: 5 V (fully compatible with Arduino and ESP32)
- Best for: PWM LED dimming, DC motor speed control, solenoids, relays, and other high-current loads.
L298N Dual H-Bridge Motor Driver Module
-
Drive Capability: 2 DC Motors or 1 Stepper Motor.
-
Voltage: 5V - 35V DC.
-
Current: 2A per channel (Max).
-
Heatsink: Large aluminum heatsink for cooling.
-
Best For: 2WD/4WD Robot Cars and High-Torque Motors.
LDR Photosensitive Sensor Module (4-Pin) | Light Detector
- Sensor Type: Light Dependent Resistor (Photoresistor).
-
Outputs: Digital (D0) & Analog (A0).
-
Sensitivity: Adjustable via Blue Potentiometer.
- Best For: Automatic Lights, Sun Trackers, and Laser Tripwires.
LM2596 DC-DC Buck Converter Module | Adjustable Step-Down Regulator (3A)
-
Input: 3V - 40V DC.
-
Output: 1.5V - 35V DC (Adjustable).
-
Current: Max 3A.
-
Best For: Powering Arduinos from 12V batteries, Solar Projects, and LED Drivers.
LM358 Dual Op-Amp IC | Low Power Operational Amplifier (DIP-8)
The industry-standard chip for audio and signals. The LM358 contains two independent, high-gain operational amplifiers in a single 8-pin package. Unlike the older 741 Op-Amp, the LM358 is designed to work perfectly with a single power supply (like a battery).
-
Package: DIP-8 (Breadboard Friendly)
-
Supply Voltage: 3V to 32V
-
Best For: Pre-amplifiers, Active Filters, and Line Following Robots (Comparator).
Male to Female Jumper Wires (40pcs) | 20cm Dupont Cable
The ultimate bridge cable. These wires have a pin on one side and a socket on the other. They are the standard cable for connecting sensors (with pins) directly to your Arduino, or connecting a Raspberry Pi to a breadboard.
-
Quantity: 40 Wires (Peelable Ribbon)
-
Length: 20cm
-
Connectors: Male to Female
-
Best For: Raspberry Pi to Breadboard, IR Sensors to Arduino.
Male to Male Jumper Wires (40pcs) | 20cm Dupont Cable for Breadboard
The essential cables for every electronics project. This is a peelable ribbon of 40 multi-colored wires with male pins on both ends. Perfect for connecting your Arduino Uno directly to a breadboard without soldering.
-
Quantity: 40 Wires (Peelable Ribbon)
-
Length: 20cm (Standard)
-
Connectors: Male to Male
-
Best For: Breadboarding, Arduino prototyping, and testing circuits.
MAX7219 4-in-1 Dot Matrix LED Display Module | Red Scrolling Text
Create your own digital sign board. This module combines four 8x8 LED matrices into a single display. It is pre-wired and ready to scroll text, numbers, and symbols using just 3 pins on your Arduino.
-
Resolution: 32 x 8 Pixels (Total 256 LEDs)
-
Color: Red
-
Interface: SPI (DIN, CS, CLK)
-
Best For: Digital clocks, scrolling message boards, and counters.
MG996R 360° Continuous Rotation Servo Motor | High Torque Metal Gear
The muscle for your heavy-duty robot. Unlike standard servos that stop at 180 degrees, this 360° Continuous Rotation version spins freely like a wheel. It combines the high torque of a servo with the continuous motion of a DC motor.
-
Gears: Full Metal (Brass/Aluminum)
-
Torque: 11kg/cm (Very Strong)
-
Type: 360° Continuous (Acts like a DC Motor)
-
Best For: Robot wheels, conveyor belts, and winches.
Mini Submersible Water Pump 3V-5V | Horizontal Motor for Arduino
Build your own automatic watering system. This compact submersible pump is designed to move water quietly and efficiently. Perfect for Arduino irrigation projects, small aquariums, and desktop fountains.
-
Voltage: 3V to 5V DC (USB Compatible)
-
Flow Rate: 80-120 Liters/Hour
-
Outlet Diameter: 7.5mm (Fits our 6mm/8mm PVC Hose perfectly)
-
Type: Submersible (Must be under water to work)
Mounting Bracket Holder for Ultrasonic Sensor HC-SR04
MQ-135 Air Quality & Hazardous Gas Sensor Module | CO2, Smoke, Ammonia
Detect smoke and dangerous gases instantly. The MQ-135 is the most versatile gas sensor for air quality monitoring. It detects a wide range of gases including Ammonia, Sulfide, Benzene, Smoke, and CO2. Perfect for "Smart Home" safety systems and environmental monitoring.
- Gases Detected: NH3, NOx, Alcohol, Benzene, Smoke, CO2.
-
Output: Analog (Gas Concentration) and Digital (Alarm Trigger).
-
Warm-up Time: ~20 seconds.
-
Best For: Air Quality Monitors, Smoke Alarms, and Industrial Safety.
MQ-2 Smoke & Gas Sensor Module | LPG, Butane, Hydrogen Detector
- Detects: Smoke, LPG, Propane, Hydrogen, Methane.
- Sensitivity: High (Adjustable).
- Response Time: < 10s.
- Best For: Fire Alarms, Gas Leak Detectors, and Industrial Safety.